Techno-economic-environmental evaluation of a combined tri and dry reforming of methane for methanol synthesis with a high efficiency CO2 utilization

Production of methanol, as a green energy, from syngas is coming into focus. However, natural gas based methanol plants, which are used steam reforming of methane for syngas production, have a high CO₂ emission resulting in the global warming. In this study, a novel process for methanol synthesis is proposed to reduce CO₂ emission. In this regard, natural gas and flue gas are fed to a parallel-series system with tri and dry reforming of methane for syngas production with the optimized stoichiometric number. Then, the produced syngas is converted to methanol in a reactor. Finally, the produced methanol is purified by two distillation towers. The proposed method is compared to a referenced method in the view of technological, economic and environmental metrics. The techno-economic-environmental analysis of the processes reveals that not only the proposed method, as compared to the referenced one, increases CO₂ conversion from 20.93% to 99.22%, but also it is more economical and environmentally friendly. In addition, the global warming potential of the proposed method is almost 60% lower than that for the referenced method due to the lower CO₂ emission. Therefore, the proposed method can save above MUS$ 8 a year by CO₂ capture.     

Application of artificial neural network method to predict the breakage properties of PGE bearing chromite ore

In the present investigation, systematic grinding experiments were conducted in a laboratory ball mill to determine the breakage properties of low-grade PGE bearing chromite ore. The population balance modeling technique was used to study the breakage parameters such as primary breakage distribution (B_{i, j}) and the specific rates of breakage (S_i). The breakage and selection function values were determined for six feed sizes. The results stated that the breakage follows the first-order grinding kinetics for all the feed sizes. It was observed that the coarser feed sizes exhibit higher selection function values than the finer feed size. Further, an artificial neural network was used to predict breakage characteristics of low-grade PGE bearing chromite ore. The predicted results obtained from the neural network modeling were close to the experimental results with a correlation of determination R² = 0.99 for both product size and selection function.     

Experimental and numerical investigations on the heat production and thermal storage characteristics of rapid preparation amorphous powder activated coke

The heat production and thermal storage characteristics of rapid-preparation amorphous powder activated coke (RAC) were investigated. RAC was prepared by using a drop-tube reactor system. The natural oxidation characteristics of RAC were studied through combined TG–FTIR analysis and temperature-programmed experiment. Experimental results showed that CO and CO₂ were the main oxidation products of RAC in air, and that the oxidation reaction was in accordance with the Arrhenius equation and law of mass action. Thermal storage characteristics were studied through computational fluid dynamics simulation. The maximum excess temperature θ_max increases linearly with the increase of the initial temperature. The concentration fields of the products show that CO₂ is mainly concentrated in the upper part of the coke bin, and the CO generated by CO₂ at high temperature is mainly concentrated in the central part of the coke bin.     

Thermal properties of hierarchical YSZ and LZO ceramic microspheres with multi-scaled voids investigated by using theoretical,experimental and simulation methods

Heat transfer within ceramic feedstock powders is still unclear, which impedes optimization of the thermal and mechanical properties of the thermal sprayed coatings. The microspheres (yttria-stabilized zirconia YSZ and lanthanum zirconate LZO) were prepared via the electro-spraying assisted phase inversion method (ESP). The thermal properties of the two ESP microspheres and a commercial hollow spherical powder (HOSP) were investigated by using theoretical, experimental, and simulation methods. Thermal conductivity of the single microsphere was estimated via a novel nest model that was derived from the Maxwell-Eucken 1 and the EMT model. Thermal conductivity of a single YSZ/LZO-ESP microsphere prepared at 1100–1200 °C was within 0.36–0.75 W/m K, which was ～ 20 % lower than that of a single YSZ-HOSP microsphere with a similar porosity. Heat flux simulation showed that high tortuosity around the multi-scaled voids of the ESP microsphere led to a more efficient decrease in thermal conductivity compared with total porosity.     

Novel proton-conducting layered perovskite based on BaLaInO4 with two different cations in B-sublattice: Synthesis,hydration, ionic (O2−, H+) conductivity

The present study focused on the novel material with significantly improved properties for the application in the area of clean energy. The new complex oxide BaLaIn_0·5Y_0·5O₄ with layered perovskite structure was obtained for the first time. It was proved that the introduction of Y³⁺ ions in the perovskite layer of BaLaInO₄ leads i) to the rise of the oxygen-ionic conductivity due to the increase in mobility of oxygen ions as a result of the expand of the cell volume and ii) to the enhancement of protonic conductivity due to the increase in the proton concentration and mobility. The sample BaLaIn_0·5Y_0·5O₄ is nearly pure proton conductor below 400 °C and has the protonic conductivity value 1.6?10^?5 S/cm at this temperature.     

Techno-economic assessment of hydrogen refueling station: A case study in Croatia

Hydrogen refueling station (HRS) capacity and location depend on the users, which makes it difficult to select the most favorable option before potential users are actually identified. As in Croatia, at least for now, there are no hydrogen users, this study considers a wide range of HRS capacities and their different configurations. These include hydrogen production and charging station within one existing wind farm in Croatia or both nearby the users, the hydrogen production within the wind farm and the charging station nearby the users, while hydrogen is delivered to the station with a tube trailer, and configuration of hydrogen production within the wind farm with a mobile charging station in case of several users in different locations. Each HRS configuration is evaluated by the obtained levelized cost of hydrogen depending on the capital, and operation and maintenance costs within the HRS techno-economic analysis provided.     

C105管桩混凝土设计参数取值的探讨

通过试验得出了C105混凝土100 mm×100 mm×100 mm立方体非标准试件抗压强度换算系数以及C105混凝土的标准方差和强度变异系数。采用理论计算,得到了棱柱体抗压强度与立方体抗压强度的比值α_c1,并与试验实测平均值进行了比较,验证了理论计算方法的可行性。此外,通过对比分析,探讨了直接外延法和引用公式法两种C105混凝土设计参数计算方法的正确性,研究结果可为C105管桩混凝土的设计和应用提供参考。     

日本の寒地，北海道における2030年代の水稲生育への温暖化の影響予測とその対応(日语原文)

北海道では1980年代から2010年代まで，水稲圃場栽培期間である5–9月の気温は年代とともに上昇した。そこで，直近の2010年代（2010—2019年平均）と比べて， 2つの2030年代の予測気象から，既報の関係式より水稲生育を予測した。その結果，2030年代では2010年代に比べ，限界移植日（移植早限）が水稲栽培17地域の平均で8～9日早い。また，早限出穂期が1～5日早く，晩限出穂期が1～5日遅く，安全出穂期間が2～10日長い。出穂期は1～3日早い。出穂期から晩限出穂まで2～9日長いため，遅延型冷害の発生がやや少ない。生育期別気象は，出穂前24日以降30日間では生育が早いため平均気温が同じかやや低い。出穂前10日以降40日間および出穂期以降40日間では平均気温がやや高く，日射量はやや少ない。そのため，玄米収量は96～98％とやや低く，潜在収量性を示す気候登熟量示数は同じである。障害不稔発生に関係する穂ばらみ期冷害危険期の平均気温はわずかに低いかほぼ同じであるため，冷害発生の危険性は残る。一方，不稔発生をもたらす低温域の出現頻度には，地域間で差異がある。精米蛋白質含有率は同じであるが，アミロース含有率はやや低く，やや良食味である。米粒外観品質では被害粒歩合と着色粒歩合は一定の傾向がなく，未熟粒歩合はやや高い。精米白度は同じであるが，玄米白度はやや高い。以上の予測に対する技術的対応方向を示した。     

Consolidation considering increasing soil column radius for dredged slurries improved by vacuum preloading method

Soil column is often investigated in the improvement of dredged slurries. Different from the smear zone, the soil column forms gradually and has extremely low permeability. This study presents an analytical solution for soil consolidation considering the increasing radius of the soil column and time-dependent discharge capacity. Based on the solution, the influence of the radius' increase on the consolidation behavior is found significant when the soil column has low permeability and large final radius, and the increase of formation time can lead to the increase of consolidation speed and final consolidation degree.     

汉江上游干支流沉积物细菌群落多样性和影响因素

为了解汉江上游干支流沉积物细菌多样性以及确定性过程和随机性过程在沉积物细菌群落构建过程中的相对重要性,基于Illumina高通量测序技术,分析了环境因子对细菌群落组成的影响,采用非度量多维尺度(NMDS)排序探究了季节之间沉积物细菌群落的差异,并结合中性群落模型和标准化随机率量化了确定性过程和随机过程对群落构建的影响。结果表明:汉江上游及其支流细菌群落主要由变形菌门(Proteobacteria)、拟杆菌门(Bacteroidetes)、蓝藻门(Cyanophyta)、浮霉菌门(Planctomycetes)和酸杆菌门(Acidobacteria)等组成；细菌群落在不同季节有显著差异；地理距离和环境因子对细菌群落结构影响较小,确定性过程并未在细菌群落组成中起到主导作用；随机过程很大程度上影响了群落在秋季和春季的组成,是沉积物细菌群落构建的主导因素。